ALRC Consultancy Services |
Design & SimulationWe provide the design and simulation simulation solutions for Radio Frequency, Microwave Antennas, Filters and develop simulation models for your ideas through the EM simulation tool ANSYS HFSS.
|
FabricationWe realize your simulation models in reality through Fabrication facility at our Research center on various substrate materials like *FR4 Epoxy, *Rogers RT/Duroid5880, *Polyimide etc.
. |
Functional VerificationOur center caters the real time functional verification of your RF-Microwave Device (Antennas, Filters, Couplers, Dividers etc) through the Combination Analyzer. The Frequency range is available upto 15 GHz. The data collected through VNA (S-parameters, VSWR, Smith Chart, Impedance Plots) will be provided.
|
Terms & Conditions
1. Our clients are requested to confirm with the availability of substrate materials and other components at our R&D center before approaching us for fabrication.
2. Clients are requested to fill the form available at arllcrcklu.weebly.com/consultancy.html or mail to [email protected] .
and attach the form (after filling) below
alrc_consultancy_form.docx
3. As per the instructions from our department of ECE, KLEF, the above mentioned services are chargeable according to the complexity of your work. Following are the charges as per the directions from our Department of ECE, KLEF Consultancy policy and GST considerations:
2. Clients are requested to fill the form available at arllcrcklu.weebly.com/consultancy.html or mail to [email protected] .
and attach the form (after filling) below
alrc_consultancy_form.docx
3. As per the instructions from our department of ECE, KLEF, the above mentioned services are chargeable according to the complexity of your work. Following are the charges as per the directions from our Department of ECE, KLEF Consultancy policy and GST considerations:
- For fabrication of your design on FR-4 material, the minimum charges are Rs. 500/- for the design dimension under 5 cm x 5 cm x 1.6 mm volume. For other materials, the charges will vary.
- Additional charges will be applied for embedding additional components like SMA Launchers, PIN Diodes, Varactors, RLC elements, Dielectric Loading, metallization filling, dielectric filling etc based on complexity of the design.
- We request our customers to send your design files in .hfss, .aedt or .cst format to avail the above mentioned services. Send your simulation files to our email: [email protected]
- The fabrication and measurements (if any) will be processed within the span maximum of 15 days (based on the availabilty of materials/components/technical persons) from the date issued. The results of the model will be mailed in last week of that month and the fabricated prototype model will be dispatched at the end of the month only.
- **As per Per R&D policy, outsiders are not allowed to utilize our instruments and hourly charges are applicable for those with special permission with proper intimacy from our Director of our Research Center for utilizing our measurement facilities along with support team of faculty/ technicians/ research scholars.
- We ensure calibration of our instruments prior to do functional verification and our people will follow measurement guidelines as instructed by the instrument maker. However few percent of error may exist due to simulation environment and practical limitations. Hence we are not responsible for any result mismatch and we never entertain any such discussions or arguments regarding this.